Q1: Open the bonnet, identify where you would check the engine oil level and tell me how you would check that the engine has sufficient oil.
Q2:
Open the bonnet, identify where you would check the engine coolant level and tell me how you would check that the engine has the correct level.
A: Identify high/low level markings on header tank where fitted or radiator filler cap, and describe how to top up to correct level.
Q3: Identify where the windscreen washer reservoir is and tell me how you would check the windscreen washer level.
A: Identify reservoir and explain how to check level.
Q4: Open the bonnet, identify where the brake fluid reservoir is and tell me how you would check that you have a safe level of hydraulic brake fluid.
A: Identify reservoir, check level against high/low markings
.
Q5: Show me / explain how you would check that the power assisted steering is working before starting a journey.
A: Before starting a journey two simple checks can be made. Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate.
Alternatively turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning.
Q6: Show me how you would check the parking brake for excessive wear.
A: Demonstrate by applying parking brake that when it is fully applied it secures itself, and is not at the end of the working travel.
Q7: Show me how you would check that the horn is working (off road only).
A: Check is carried out by using control (turn on ignition if necessary).
Q8: Show me how you would check that the direction indicators are working.
A: Applying the indicators or hazard warning switch and check functioning of all indicators.
Q9: Tell me how you would check that the brake lights are working.
A: Operate brake pedal, make use of reflections in windows, garage doors, etc, or ask someone to help.
Q10: Tell me how you would check that the brakes are working before starting a journey.
A: Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side.
Q11: Show me how you would check that the headlights & tail lights are working.
A: Operate switch (turn on ignition if necessary), walk round vehicle.
Q12: Tell me where you would find the information for the recommended tyre pressures for this car and how tyre pressures should be checked.
A: In manufacturer’s guide, use a reliable pressure gauge, check and adjust pressures when tyres are cold, don’t forget spare tyre, remember to refit valve caps.
Q13: Tell me how you would check the tyres to ensure that they have sufficient tread depth and their general condition.
A: No cuts and bulges, 1.6mm of tread depth across the central ¾ of the breadth of the tyre and around the entire outer circumference.
Show & Tell
The DSA Show me, tell me questions test your knowledge on basic car maintenance and safety. At the beginning of the driving test the examiner will ask you two questions, one show me and one tell me. If you answer any of these two questions incorrectly and you will be given one driving test fault. There are 13 different questions which can be asked in 12 different combinations.